SX4 2WD L4-2.0L (2007)
Wiper Arm: Service and Repair
Rear Wiper Removal and Installation
REAR WIPER REMOVAL AND INSTALLATION
Removal
1. Disconnect negative (-) cable at battery.
2. Remove arm cover (1), rear wiper arm nut (2), rear wiper arm with blade assembly (3), rear wiper pivot cap (4), rear wiper nut (5) and rear wiper
seal (6).
3. Remove rear end door trim referring to Rear End Door Lock Assembly Removal and Installation.
4. Disconnect coupler from rear wiper motor.
5. Remove rear wiper motor.
Installation
1. Install rear wiper motor (1) and tighten rear wiper motor mounting bolts to specified torque.
Tightening torque
Rear wiper motor mounting bolt a: 8 Nm (0.8 kgf-m, 6.0 ft. lbs.)