SX4 4WD L4-2.0L (2008)
Leak Detector: Testing and Inspection
EVAP Leak Check System Smoke Test
EVAP Leak Check System Smoke Test
WARNING: Use the nitrogen gas. If other kind of gas is used instead of the nitrogen gas, the gasoline may ignite and explode.
CAUTION: Do not use smoke for any other systems except the evaporative emission system in order to prevent performance degradation of
the other systems.
NOTE:
^
The vehicle battery must be fully charged for optimum tester performance.
^
It is not recommended to use the tester in an outside repair bay area because wind and/or bright sunlight could make the tester very difficult to
read.
1. Connect the red battery clip from the tester to the positive battery terminal, and then connect the black battery clip from the tester to chassis
ground.
NOTE: Unwind the nitrogen/smoke hose completely from the bracket to optimize the tester s performance.
2. Connect the nitrogen/smoke hose onto the fuel cap adapter (1).
3. Remove fuel cap, and then install fuel cap adapter onto the fuel filler neck.