SX4 4WD L4-2.0L (2008)
2)
Disconnect gear shift and gear select control cables from transaxle.
3)
Remove gear shift interlock bolt (1) and 5th to reverse interlock guide bolt (2) from transaxle case.
4)
Remove gear shift & select shaft assembly (3).
Installation
1)
Clean mating surface of guide case (1) and left case (5), apply sealant to left case as shown in figure by such amount that its section is 1.5 mm
(0.059 in.) in diameter, mate guide case with left case.
"B": Sealant 99000-31260 (SUZUKI Bond No.1217G)
2)
Install guide case bolts No. 1 to which thread lock cement has been applied and guide case bolts No. 2 (2), and tighten them to specified torque.
:Sealant 99000-31260 (SUZUKI Bond No. 1217G)
Tightening torque
Guide case bolt No. 1: 23 Nm (2.3 kgf-m, 17.0 lbft)
Guide case bolt No. 2 (a): 23 Nm (2.3 kgf-m, 17.0 lb-ft)