SX4 4WD L4-2.0L (2008)
Liftgate Window Glass: Service and Repair
REAR END DOOR GLASS REMOVAL AND INSTALLATION
Reference: Rear End Door Window Components
Refer to Windshield Removal and Installation as preparation, removal and installation procedures are basically the same. However, note the following.
^
Observe the following precautions when applying adhesive (1) along glass (2) edge.
^
Adhesive (1) should be applied evenly especially in height.
^
Be careful not to damage primer (3).
^
Install glass (2) on rear end door panel (5) noting the following.
^
With the position of fastener (4) properly aligned.
^
With the position of ceramic mark (6) aligned to the mark (7) of rear end door panel (5).
^
Press glass against body quickly after adhesive (1) is applied.
Adhesive amount specifications and position for rear end door glass
^
Height "a": 13 mm (0.51 in.)
^
Width "b": 7 mm (0.28 in.)
^
Width "c": 14 mm (0.55 in.)
^
Position "d": 15 mm (0.59 in.)
^
Position "e": 42 mm (1.65 in.)
^
Position "f": 37 mm (1.46 in.)
^
Position "g": 9 mm (0.35 in.)
^
Position "h": 14 mm (0.55 in.)