Verona L6-2.5L (2005)
Stabilizer Link: Service and Repair
Front
Stabilizer Link
Removal
1. Raise and suitable support the vehicle.
2. Remove the stabilizer shaft-to-stabilizer link nut.
3. Remove the stabilizer link-to-control arm nut.
4. Remove the stabilizer link.
Installation
1. Install the stabilizer link and nuts.
2. Lower the vehicle so the control arms are supported by jack stands.
CAUTION: The weight of the vehicle must be supported by the control arms before the stabilizer link-to-control arm nuts or the stabilizer
shaft-to-stabilizer link nuts are tightened. This can be done by lowering the vehicle onto jack stands under the control arms.
Tighten: The stabilizer link nuts to 50 Nm (37 ft. lbs.).