Vitara JLS (2Dr) 2WD L4-2.0L (2001)
3. Disconnect ABS actuator assembly connector
4. Remove bolt (2) and take out ABS actuator assembly (1) from bracket (3).
CAUTION:
^
Do not give an impact to ABS actuator assembly.
^
Use care not to allow dust to enter ABS actuator assembly.
^
Do not place hydraulic unit on its side or upside down. Handling it in inappropriate way will affect its original performance.
INSTALLATION
Install ABS actuator assembly by reversing removal procedure.
^
Tighten bolt and nut to specified torque
Tightening torque
Break pipe flare nut (a): 16 Nm (1.6 kg-m, 12.0 ft. lbs.)
ABS actuator assembly bolt (b): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
ABS actuator assembly bracket bolt (c): 10 Nm (1.0 kg-m, 7.5 ft. lbs.)
^
Bleed air from brake system .