Vitara JLS (4Dr) 2WD L4-2.0L (2000)
2. Tighten wheel cylinder to brake back plate to specified torque.
3. Torque flare nut (or nuts) of brake pipe which was connected in step 1) to specification.
Tightening Torque
(a): 8.5 Nm (0.85 kg.m, 6.5 ft. lbs.)
(b): 16 Nm (1.6 kg.m, 12.0 ft. lbs.)
4. Install bleeder plug cap taken off from pipe back to bleeder plug.
5. For procedure hereafter, refer to steps 1) to 5) of BRAKE SHOE INSTALLATION.
NOTE: Be sure to bleed brake system.
(For G16 or J20 engine vehicle)
1. Install gasket to joint seam of wheel cylinder and brake back plate. Then take off bleeder plug cap from brake pipe and connect pipe (for pipes) to
wheel cylinder just enough to prevent fluid from leaking.
NOTE: Be sure to check gasket for deterioration or any damage before installation and replace if found defective.
2. Tighten wheel cylinder to brake back plate to specified torque.
3. Torque flare nut (or nuts) of brake pipe which was connected in step 1) to specification.
Tightening Torque
(a): 11 Nm (1.1 kg.m, 8.0 ft. lbs.)
(b): 16 Nm (1.6 kg.m, 12.0 ft. lbs.)
4. Install bleeder plug cap taken off from pipe back to bleeder plug.
5. For procedure hereafter, refer to "BRAKE SHOE".
NOTE: Be sure to bleed brake system.