Vitara JLX (2Dr) 4WD L4-2.0L (2001)
3. Disconnect front wheel speed sensor connector (1).
4. Remove harness clamp bolts (2) and remove front wheel speed sensor (1) from knuckle.
CAUTION:
^
Do not pull wire harness when removing front wheel speed sensor.
^
Do not cause damage to surface of front wheel speed sensor and do not allow dust, etc. to enter its installation hole.
INSPECTION
Sensor
^
Check sensor for damage. If any faulty is found, replace.
^
Check sensor for resistance. If any faulty is found, replace.
Resistance between terminals of wheel speed sensor: 0.8 - 1.6 k Ohms at 20°C (68°F)
Resistance between terminal and wheel speed sensor body: 1 M Ohms or more
Sensor Rotor
^
Check rotor serration (teeth) for being missing, damaged or deformed.
^
Turn drive shaft and check if rotor rotation is free from eccentricity and looseness.
^
Check that no foreign material is attached. If any faulty is found, repair or replace.
INSTALLATION
1. Check that no foreign material is attached to sensor and rotor.