Vitara JLX (2Dr) 4WD L4-2.0L (2001)
2. In order to remove sensor rotor (3) from retainer ring (2), grind with a grinder one part "A" of the sensor rotor (3) as shown till it becomes thin.
CAUTION:
^
Cover vinyl sheet (4) or the like over wheel bearing so that fine grains from grinding will not enter there.
^
Be careful not to go so far as to grind the retainer ring.
3. Break with a chisel (1) the thin ground sensor rotor (2), and it can be removed.
INSTALLATION
1. Press-fit sensor rotor (1) as shown in the figure.
NOTE: Use care not to cause any damage to outside of retainer ring.
2. Install rear axle shaft assembly.