Vitara JS (2Dr) 2WD L4-1.6L DOHC MFI (1999)
1) When positioning thermostat and O-ring on thermostat case, be sure to position it so that
^
air bleed valve comes at top (G16 engine)
^
air bleed valve comes at match mark and into the recession of thermostat case (J20 engine).
2) Install thermostat cap to intake manifold (G16 engine), water pump (J20 engine).
3) Fill cooling system. Refer to Cooling System; Service and Repair.
4) Connect negative cable at battery.
5) After installation, check each part for leakage.