X-90 (2WD) L4-1591cc 1.6L SOHC MFI (1997)
Load Compensator: Service and Repair
REMOVAL
1. Clean around reservoir cap and take out fluid with syringe or equivalent.
2. Hoist vehicle.
3. Disconnect brake pipes from LSPV.
4. Remove LSPV assembly from vehicle body. As shown, LSPV assembly should be removed together with its spring and stay installed as they are.
5. Remove spring and stay from lever.
CAUTION:
^
None of the nuts and bolt of the LSPV assembly should be loosened or tightened.
^
LSPV assembly must not be disassembled.
^
Replace with new one if defective.
INSTALLATION
Install by reversing removal procedure, noting the following.
1. Apply multi-purpose grease to upper and lower joint of coil spring.