X-90 (2WD) L4-1591cc 1.6L SOHC MFI (1997)
Vacuum Brake Booster: Service and Repair
REMOVAL
1. Remove the ABS actuator and then the master cylinder assembly.
2. Disconnect brake vacuum hose from brake booster.
3. Disconnect push rod clevis from brake pedal arm.
4. Remove attaching nuts and then booster as shown.
CAUTION: Never disassemble brake booster. Disassembly will spoil its original function. If is found faulty, replace it with new one.
INSTALLATION
NOTE:
^ Check length of push rod clevis.
^ Before installing master cylinder, adjust booster piston rod.
^ Apply silicone grease to master cylinder piston.