Steering Column Lock Replacement for X-90 (2WD) L4-1591cc 16L SOHC MFI (1997)
Steering Column Lock: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery terminal.
2. Disable air bag system. Refer to Air Bags and Seat Belts.
3. Remove steering column. See: Service and Repair
4. Using center punch as shown, loosen and remove steering lock mounting bolts.
NOTE: Use care not to damage aluminum part of steering lock body with center punch.
5. Turn ignition key to "ACC" or "ON" position and remove steering lock assembly from steering column.
INSTALLATION
1. Position oblong hole of steering shaft in the center of hole in column.
2. Turn ignition key to "ACC" or "ON" position and install steering lock assembly onto column.
3. Now turn ignition key to "LOCK" position and pull it out.
4. Align hub on lock with oblong hole of steering shaft and rotate shaft to assure that steering shaft is locked.
5. Tighten two new bolts until head of each bolt is broken off.
6. Turn ignition key to "ACC" or "ON" position and check to be sure that steering shaft rotates smoothly. Also check for lock operation.
7. Install steering column. See: Service and Repair
8. Connect negative battery cable.