X-90 (2WD) L4-1591cc 1.6L SOHC MFI (1997)
1. Insert new stud in hub hole. Rotate stud slowly to assure serrations are aligned with those made by original bolt.
2. Using special tools, press-fit bearing outer race until its end contacts stepped surface of wheel hub.
Special Tool:
(D): 09944-68210
(E): 09924-74510 or equivalents.
NOTE:
^
As front wheel bearing is cassette type double taper roller bearing, it must be replaced as whole unit when replacement becomes necessary.
^
Cassette type double taper roller bearing is so designed as to provide proper pre-load as long as it is tightened to specified torque. Therefore, it
requires no pre-load check after installation, unlike conventional taper roller bearing.
^
Apply wheel bearing grease between bearings.
"A": Grease 99000-25010 or equivalent.
3. Install bearing circlip.