X-90 (4WD) L4-1591cc 1.6L SOHC MFI (1998)
2. Aligning serrations between new stud bolt(s) and flange, install new stud bolt(s) by tightening nut as shown.
3. Install bearing retainer to shaft.
4. Press-fit wheel bearing and retainer ring as shown.
NOTE:
^
Use care not to cause any damage to outside of retainer ring.
^
Refer to figure so that wheel bearing is installed in proper direction.
5. Apply grease to axle shaft inner oil seal lip as shown.
"A": grease 99000-25010 or equivalent.