X-90 (4WD) L4-1591cc 1.6L SOHC MFI (1998)
Throttle Cable/Linkage: Adjustments
Kick-Down Cable Adjustment (A/T Only)
Without O/D
1) Make sure that accelerator cable play is within specification.
2) Loosen kickdown cable lock nut and adjusting nut considerably.
3) With accelerator pedal depressed fully and kickdown cable pulled in A direction, adjust lock nut-to-bracket clearance to 0 - 1 mm (0 - 0.039
in.) by turning lock nut.
NOTE: When adjusting clearance, make sure that adjusting nut does not contact against bracket.
Clearance "a": 0 - 1 mm (0 - 0.039 in.)
4) Release accelerator pedal and adjust lock nut-bracket clearance as specified above by tightening adjusting nut using care to keep lock nut in
place.
Turn adjusting nut at such position as shown with dotted line in figure, where it can be turned smoothly. When adjusting nut position is
determined, fit adjusting nut to bracket as shown with solid line.
5) With adjusting nut positioned as shown with solid line, tighten lock nut securely.
With O/D