X-90 (4WD) L4-1591cc 1.6L SOHC MFI (1998)
2. Rear bushing.
Using special tool, press-fit rear bushing so that lower arm housing is held between its flanges as shown.
Special Tool (D): 09951-16040 or equivalent.
NOTE: When press-fitting bushing, soap water applied to outside of bushing will facilitate work.
3. Install ball stud to lower arm.
Tightening torque (a): 85 Nm (61.5 ft. lbs.)
4. Install lower arm to chassis.
Tightening Torque:
(b): 85 Nm (61.5 ft. lbs.)
(c): 115 Nm (83.5 ft. lbs.)
5. As installation procedure hereafter is the same as that for coil spring.