XL-7 2WD V6-3.6L (2007)
NOTE: Do not direct a hard stream of high pressure water to the freshly applied urethane adhesive.
29. Use a soft spray of warm water in order to immediately water test the window.
30. Inspect the window for leaks.
31. If any leaks are found, use a plastic paddle in order to apply extra urethane adhesive at the leak point.
32. Retest the window for leaks.
WARNING: Insufficient curing of urethane adhesive may allow unrestrained occupants to be ejected from the vehicle resulting in
personal injury.
^
For the moisture-curing type of urethane adhesive, allow a minimum of 6 hours at 21°C (70°F) or greater and with at least 30 percent
relative humidity. Allow at least 24 hours for the complete curing of the urethane adhesive.
^
For the chemical-curing type of urethane adhesive, allow a minimum of 1 hour.
Do NOT physically disturb the repair area until after these minimum times have elapsed.
33. Maintain the following conditions in order to properly cure the urethane adhesive:
^
Partially lower a door window in order to prevent pressure buildups when closing doors before the urethane adhesive cures.
^
Do not drive the vehicle until the urethane adhesive is cured. Refer to the above curing times.
^
Do not use compressed air in order to dry the urethane adhesive.
34. Complete the window installation.