XL-7 2WD V6-3.6L (2007)
8. Using a pair of channel lock(R) pliers, slide the springs from the notches in the frame to the pin.
9. Adjust the seat back to ensure proper operation.
10. If the seat is equipped with lumbar support, perform the following procedure:
a. Pull back on the lumbar cable sleeve.
b. Install the barrel end of the cable from the lumbar actuator.
c. Adjust the knob to ensure that the cable is properly installed.
11. Install the seat back trim cover and pad. Refer to [Front Seat Back Cushion Cover and Cushion Pad Replacement (Non Fold Flat)] [Front Seat
Back Cushion Cover and Cushion Pad Replacement (Fold Flat)].
12. Install the front seat to the vehicle. Refer to [Front Seat Replacement - Bucket].