XL-7 2WD V6-3.6L (2007)
6. Remove the caps or plugs from the brake pipe fitting end and the brake hose end.
7. Using a backup wrench on the hose fitting, connect the brake pipe fitting at the front brake hose.
Tightening torque
Tighten the fitting to 18 Nm (13 lb ft).
8. Install the brake hose retaining clip to the brake hose and the brake hose mounting bracket.
9. Install the tire and wheel assembly.
10. Ensure that the hose does not make contact with any part of the suspension. Check the hose in extreme right and extreme left turn conditions. If the
hose makes contact, remove the hose and correct the condition.
11. Bleed the hydraulic brake system.
12. Lower the vehicle.