XL-7 2WD V6-3.6L (2007)
1. Inspect the area of brake pipe to be repaired or replaced.
2. Release the brake pipe to be replaced from the retainers, as required.
3. Select an appropriate location to section the brake pipe, if necessary.
^
Allow adequate clearance in order to maneuver the J 45405.
^
Avoid sectioning the brake pipe at bends or mounting points.
4. Using a string or wire, measure the length of the pipe to be replaced including all pipe bends.
5. Add to the measurement taken the appropriate additional length required for each flare to be created.
Specification
^
6.35 mm (0.250 in) for 4.76 mm (3/16 in) diameter pipe
^
9.50 mm (0.374 in) for 6.35 mm (1/4 in) diameter pipe
^
12.67 mm (0.499 in) for 7.94 mm (5/16 in) diameter pipe
NOTE:
Ensure that the brake pipe end to be flared is cut at a square, 90 degree angle to the pipe length.
6. Using the pipe cutter included in the J 45405, carefully cut the brake pipe squarely to the measured length.
7. Remove the sectioned brake pipe from the vehicle.
8. Select the appropriate size of brake pipe and tube nuts, as necessary. The brake pipe outside diameter determines brake pipe size.
