XL-7 2WD V6-3.6L (2007)
Intake Manifold: Procedures
Intake Manifold Cleaning and Inspection
Upper Intake Manifold Cleaning Procedure
1. Remove any remaining gasket and/or gasket material from the following:
^
Throttle body
^
Intake manifold
2. Clean the following intake manifold areas in solvent.
^
Intake manifold gasket sealing areas
^
Intake manifold passages
^
Brake booster hose passage
^
Evaporative emission (EVAP) solenoid passage
^
Positive crankcase ventilation (PCV) vacuum hose passages
WARNING: Refer to [Safety Glasses Caution].
3. Dry the upper intake manifold and throttle body with compressed air.
Inspection Procedure
1. Inspect the upper intake manifold for the following conditions:
^
Damage, debris or restrictions to the PCV system hose port (1)
^
Damage, debris or restrictions to the EVAP purge solenoid port (2)
^
Damage to the intake manifold bolt bosses (3)
^
Damage to the EVAP purge solenoid mounting boss (4)
^
Damage, debris or restrictions to the brake vacuum booster hose port (5)
^
Damage or corrosion to the intake manifold expansion plugs (6)
^
Damage to the engine coolant air bleed pipe bracket mounting boss (7)