XL-7 2WD V6-3.6L (2007)
Camshaft Gear/Sprocket: Service and Repair
Camshaft Position Actuator Replacement - Bank 2 (Left Side) Exhaust
Camshaft Position Actuator Replacement - Bank 2 (Left Side) Exhaust
Special Tool
EN-48313 Timing Chain Retention Tool
Removal Procedure
1. Remove the lower intake manifold with the upper manifold.
2. Remove the left camshaft cover.
3. Remove the left intake and exhaust camshaft position sensors.
4. Remove the left intake and exhaust camshaft position actuator solenoid.
NOTE: Rotate the crankshaft balancer bolt in a clockwise direction ONLY.
5. Rotate the crankshaft balancer using the balancer bolt until the camshafts are in a neutral (low tension) position. The camshafts will be parallel
with the camshaft cover rail (1).