XL-7 2WD V6-3.6L (2007)
^
Left rear door ajar switch ground circuit terminal 6
^
Front passenger door ajar switch ground circuit terminal 3
^
Right rear door ajar switch ground circuit terminal 3
^
If greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, verify the scan tool Passenger Door Ajar Sw. parameter is Door Closed.
^
If not the specified value, test the signal circuit terminal listed below for a short to ground. If the circuit tests normal, replace the BCM.
^
Left rear door ajar switch ground circuit terminal 4
^
Right rear door latch signal circuit terminal 4
^
Front passenger door latch signal circuit terminal 1
4. Install a 3 A fused jumper wire between the signal circuit terminal and the ground circuit terminal listed below. Verify the scan tool Passenger
Door Ajar Sw. parameter is Door Ajar.
^
Left rear door latch signal circuit terminal 4 and ground circuit terminal 6
^
Right rear door latch signal circuit terminal 4 and ground circuit terminal 3
^
Front passenger door latch signal circuit terminal 1 and ground circuit terminal 3
^
If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
5. If all circuits test normal, test or replace the door latch.
Component Testing
1. Ignition OFF, disconnect the harness connector at the appropriate door latch.
2. With the switch in the open position, test for infinite resistance between the signal and the ground terminals listed below:
^
Driver door latch signal terminal 4 and ground terminal 6
^
Left rear door latch signal terminal 4 and ground terminal 6
^
Right rear door latch signal terminal 4 and ground terminal 3
^
Front passenger door latch signal terminal 1 and ground terminal 3
^
If not the specified value, replace the door latch.
3. With the switch in the closed position, test for less than 1 ohm between the signal and the ground terminals listed below:
^
Driver door latch signal terminal 4 and ground terminal 6
^
Left rear door latch signal terminal 4 and ground terminal 6
^
Right rear door latch signal terminal 4 and ground terminal 3
^
Front passenger door latch signal terminal 1 and ground terminal 3
^
If greater than the specified range, replace the door latch.
Repair Instructions
Perform the [Diagnostic Repair Verification - Vehicle Diagnostic Information] after completing the diagnostic procedure. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures
^
[Front Side Door Latch Replacement]
^
[Rear Side Door Latch Replacement]
^
[Control Module References] for BCM replacement, setup, and programming See: Testing and Inspection/Programming and Relearning
