XL-7 2WD V6-3.6L (2007)
3. Install the CMP actuator solenoid valve bolt.
Tightening torque
Tighten the bolt to 10 N.m (89 lb.in).
4. Connect the engine wiring harness electrical connector (2) to the bank 2 intake CMP actuator solenoid valve.
5. Install the engine mount strut bracket. Refer to [Engine Mount Strut Bracket Replacement - Right Side].
Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust
Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust
Removal Procedure
1. Remove the engine mount strut bracket. Refer to [Engine Mount Strut Bracket Replacement - Right Side].
