XL-7 2WD V6-3.6L (2007)
Evaporative Emissions Hose: Removal and Replacement
Evaporative Emission Pipe Replacement
Removal Procedure
WARNING: Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work
is being done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.
WARNING: Refer to Gasoline/Gasoline Vapors Caution in Cautions and Notices.
WARNING: Whenever fuel lines are removed, catch fuel in an approved container. Container opening must be a minimum of 300 mm (12 in)
diameter to adequately catch the fluid.
CAUTION: Fuel/Vapor lines cannot be spliced or repaired. The line must be replaced (if damaged) with the same type of line.
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
2. Disconnect the fuel feed pipe quick connect fitting (3) from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service.
3. Disconnect the evaporative emission (EVAP) pipe quick connect fitting (3) from the EVAP purge solenoid. Refer to Plastic Collar Quick Connect
Fitting Service.
