XL-7 2WD V6-3.6L (2007)
6. This step applies to Sliding Retainer style connectors ONLY. Release the fitting by pressing on one side of the release tab causing it to push in
slightly. If the tab doesn't move try pressing the tab in from the opposite side. The tab will only move in one direction
WARNING: Refer to Relieving Fuel Pressure Caution.
7. Pull the connection apart.
Installation Procedure
WARNING: Refer to Fuel Pipe Fitting Caution.
1. Apply a few drops of clean engine oil to the male connection end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.
3. Once installed, pull on both sides of the quick-connect fitting in order to make sure the connection is secure.