XL-7 2WD V6-3.6L (2007)
will absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the
connection of the fuel pressure gage is complete.
4. Wrap a shop towel around the fuel rail service port.
5. Connect the J 34730-1A to the fuel rail service port.
6. Place the hose on the J 34730-1A into an approved gasoline container.
7. Open the valve on the J 34730-1A in order to bleed any fuel from the fuel rail.
8. Close the valve on the J 34730-1A.
9. Remove the hose on the J 34730-1A from the approved gasoline container.
CAUTION: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
^
The fuel pipe connections
^
The hose connections
^
The areas surrounding the connections
NOTE: If relieving the fuel pressure for the fuel pressure gage installation and removal, it is NOT necessary to proceed with the following steps.
10. Disconnect the J 34730-1A from the fuel rail service port.
11. Remove the shop towel from around the fuel rail service port, and place in an approved gasoline container.
12. Install the fuel rail service port cap.
13. Install the engine cover, if required.
14. Tighten the fuel fill cap.
