XL-7 2WD V6-3.6L (2007)
5. Install the fuel fill tube bracket bolts (2).
Tightening torque
Tighten the bolt to 12 N.m (106 in. lbs.).
NOTE: Ensure that the fuel fill tube connecting hose is installed until it touches the fuel tank body. The hose clamp should be located within 13
mm (1/2 in) of the end of the connecting hose.
6. Position the fill tube-to-fuel tank connecting hose and hose clamp.
Tightening torque
Tighten the clamp to 5 N.m (44 in. lbs.).
7. Connect the fuel fill vent tube and fresh air hose.
8. Install the inner wheelhouse liner. Refer to Rear Wheelhouse Liner Panel Replacement.
9. Install the wheel and tire. Refer to Tire and Wheel Removal and Installation.
10. Lower the vehicle from the hoist.
11. Install the fuel fill cap.
12. Perform the Service Bay Diagnostic Test for the EVAP emission system using the scan tool. This test will verify the integrity of the vapor handling
areas of the fuel system.
13. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
