XL-7 2WD V6-3.6L (2007)
Engine Control Module: Testing and Inspection
Engine Control Module Programming and Setup
The following service procedures require either a programming or a setup event performed for a complete repair.
ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
1. ECM Reprogramming Refer to [Service Programming System (SPS)].
2. Idle Learn Procedure Refer to [Idle Learn] in Engine Controls - 3.6L (LY7).
3. Theft Deterrent Refer to [Theft Deterrent Control Module Programming and Setup]. The ECM will learn the incoming fuel continue password
immediately upon receipt of a password message. Once a password message is received, and a password is learned, a learn procedure must be
performed to change this password again. An ECM which has been previously installed in another vehicle will have learned the other vehicle's fuel
continue password, and will require a learn procedure after programming to learn the current vehicle's password.
4. Engine Oil Life Remaining When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before
the module was replaced.
5. Transmission Fluid Life Remaining When available, use the scan tool to reset the Transmission Fluid Life Remaining back to the original
percentage recorded before the module was replaced.
ECM Reprogramming
^
If the ECM needs to be reprogrammed, refer to [Service Programming System (SPS)].
^
Engine Oil Life Remaining When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before
the module was reprogrammed.
Setup for Component Replacement
The replacement of some components will require a setup procedure for complete repair. If any of the following components are replaced, an Idle Learn
Procedure must be performed. Refer to [Idle Learn] in Engine Controls - 3.6L (LY7).
^
Throttle body assembly
^
ECM
