XL-7 2WD V6-3.6L (2007)
Control Module: Service and Repair
Transmission Control Module Replacement
Removal Procedure
1. Remove the battery tray.
NOTE:
The transaxle manual shaft must be in neutral (N) position prior to re-installing the transmission control module (TCM).
2. Apply the parking brake and place control shift lever in neutral (N).
3. Remove the manual shaft detent lever (2).
4. Disconnect the electrical connectors from the TCM.
5. Remove the TCM bolts (3).
6. Remove the TCM (4) by sliding off of the manual shaft.
Installation Procedure
1. Using an adjustable wrench on the manual shaft detent lever (710), turn the shaft clockwise until it stop.