XL-7 2WD V6-3.6L (2007)
34. Disconnect the I/P module yellow harness connector (1) from the vehicle harness connector (2).
NOTE: If the vehicle is equipped with dual stage air bags the steering wheel module and I/P module will each have 4 wires. Refer to [SIR
Connector End Views] for determining high and low circuits.
35. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
36. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
37. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the passenger
deployment harness.
38. Strip 13 mm (0.5 in) of insulation from both ends of the wires.
