XL-7 2WD V6-3.6L (2007)
NOTE: Apply GM P/N 12345382 (Canadian P/N 10953489), Permatex® 24200 or equivalent on all restraint fasteners prior to installation.
1. Position the shoulder belt retractor into the center pillar positioning unit with the locking tab in the body structure notch.
CAUTION: Refer to [Fastener Notice].
2. Install the retractor fastener. Tightening torque Tighten the fastener to 45 N.m (33 lb.ft).
3. Snap the shoulder belt webbing retainer into the center pillar.
4. Install the lower garnish molding into the center pillar. Refer to [Center Pillar Lower Garnish Molding Replacement].
