XL-7 2WD V6-3.6L (2007)
5. Test for less than 2 ohms of resistance between the ground terminal C and the signal terminal A.
^
If greater than the specified range, replace the hood ajar switch.
Repair Instructions
Perform the [Diagnostic Repair Verification - Vehicle Diagnostic Information] after completing the diagnostic procedure. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures
^
[Hood Primary Latch Replacement]
^
[Control Module References] for BCM or instrument cluster replacement, programming and setup See: Testing and Inspection/Programming and
Relearning
