XL-7 2WD V6-3.6L (2007)
Oil Pressure Sender: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Turn the ignition OFF.
2. Disconnect the oil pressure sensor electrical connector.
3. Remove the oil pressure sensor (1).
Installation Procedure
CAUTION: Refer to [Fastener Notice].
1. Install the oil pressure sensor (1).
Tightening torque
Tighten the oil pressure sensor to 20 Nm (15 ft. lbs.).
2. Connect the oil pressure sensor electrical connector.