XL-7 2WD V6-3.6L (2007)
Fuel Level Sensor: Service and Repair
Fuel Level Sensor Replacement - Secondary
Fuel Level Sensor Replacement - Secondary
Removal Procedure
NOTE: A NEW fuel tank module seal is necessary each time the fuel tank module is serviced. Obtain a NEW seal prior to beginning this service
procedure.
NOTE: There are 2 fuel level sender unit and float assemblies in the fuel tank. There is 1 located on each fuel pump module. The fuel level sender unit
and float is NOT the same for each of the fuel pump modules.
1. Remove the fuel pump module. Refer to Secondary Fuel Tank Module Replacement.
2. Disconnect the fuel level sender unit and the float electrical connector.
3. Release the retaining tabs and remove the level sensor by sliding up.