XL-7 2WD V6-3.6L (2007)
1. Position the knock sensor and tighten the knock sensor bolt.
Tightening torque
Tighten the bolt to 23 N.m (17 lb.ft).
2. Connect the engine wiring harness electrical connector (2) to the bank 1 knock sensor.
3. Position the rear exhaust manifold heat shield to the engine and install the bolts.
Tightening torque
Tighten the bolts to 50 N.m (37 lb.ft).
4. Install the right catalytic converter. Refer to [Catalytic Converter Replacement - Right Side].
5. Lower the vehicle.
