XL-7 2WD V6-3.6L (2007)
3. Install the remaining attachment bolts into the APP assembly.
Tightening torque
Tighten the bolts to 25 N.m (18 lb.ft).
4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
5. Install the CPA to the APP sensor harness connector.
6. Install the driver knee bolster. Refer to [Knee Bolster Replacement].
7. Install the instrument panel left lower closeout panel. Refer to [Instrument Panel Insulator Panel Replacement - Left Side].
