XL-7 2WD V6-3.6L (2007)
1. Apply approximately 34 of the supplied grease packet into the small end of the steering gear boot cavity. Apply the remainder of the grease on the
shaft where the small end of the boot meats the shaft.
NOTE:
Ensure the large end of the boot is firmly seated in the gear housing groove.
2. Install the boot with the large clamp loosely attached but not crimped.
3. Using the J 22610, crimp the steering gear boot clamp.
NOTE:
Ensure the small end of the steering gear boot is firmly seated in the steering linkage inner tie rod end groove.