XL-7 2WD V6-3.6L (2007)
NOTE:
Do not loosen the castle nut for cotter pin installation.
6. Tighten the castle nut enough to allow for cotter pin installation.
NOTE:
The cotter pin must not contact the wheel speed sensor or drive axle.
7. Install a new cotter pin.
8. Install the outer tie rod end to the knuckle.
NOTE:
Do not allow the stabilizer link ball stud to rotate while installing the link nut.
9. Position the stabilizer shaft link to the strut assembly and install the nut.
Tightening torque
Tighten the nut to 65 Nm (48 ft. lbs.).
10. Install the wheel bearing/hub assembly.
11. Install the tire and wheel.
12. Lower the vehicle.