XL-7 2WD V6-3.6L (2007)
Transmission Mount: Service and Repair
Transmission Mount Inspection
Transmission Mount Inspection
Inspection Procedure
CAUTION:
In order to avoid oil pan damage and possible engine failure, insert a block Of wood that spans the width of the oil pan bottom between the
oil pan and the jack support.
NOTE:
Before replacing any transmission mount due to a suspected fluid loss, verify that the source of the fluid is the mount.
1. Raise the transmission/transaxle in order to relieve tension in the mount.
2. Observe the mount while raising the transmission/transaxle. Raising the transmission/transaxle removes the weight from the mount.
3. Replace the mount if it exhibits any of the following conditions:
^
The hard rubber surface is covered with heat check cracks.
^
The rubber is separated from the outer metal sleeve of the mount.
^
The rubber is split through the center of the transmission mount.
^
The mount is leaking fluid.
4. When replacing the transmission mounts or brackets, refer to the following procedures:
^
[Transmission Rear Mount Replacement (Getrag 760 Transfer Case)]
^
[Transmission Rear Mount Bracket Replacement (AWD)] [Transmission Rear Mount Bracket Replacement (FWD)] [Transmission Mount
Replacement - Left Side]