XL-7 2WD V6-3.6L (2007)
Tighten the bolts to 50 Nm(37 ft. lbs.)
3. Lower the vehicle.
Transmission Mount Inspection
Transmission Mount Inspection
Inspection Procedure
CAUTION:
In order to avoid oil pan damage and possible engine failure, insert a block Of wood that spans the width of the oil pan bottom between the
oil pan and the jack support.
NOTE:
Before replacing any transmission mount due to a suspected fluid loss, verify that the source of the fluid is the mount.
1. Raise the transmission/transaxle in order to relieve tension in the mount.
2. Observe the mount while raising the transmission/transaxle. Raising the transmission/transaxle removes the weight from the mount.
3. Replace the mount if it exhibits any of the following conditions:
^
The hard rubber surface is covered with heat check cracks.
^
The rubber is separated from the outer metal sleeve of the mount.
^
The rubber is split through the center of the transmission mount.
^
The mount is leaking fluid.
4. When replacing the transmission mounts or brackets, refer to the following procedures:
^
[Transmission Rear Mount Replacement (Getrag 760 Transfer Case)]
^
[Transmission Rear Mount Bracket Replacement (AWD)] [Transmission Rear Mount Bracket Replacement (FWD)] [Transmission Mount
Replacement - Left Side]
Transmission Front Mount Replacement
Transmission Front Mount Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Support the transaxle with an appropriate jack.
3. Remove the front transaxle mount thru bolt.