XL-7 2WD V6-3.6L (2007)
6. Install the TCM (4) over the manual shaft.
CAUTION:
Refer to [Fastener Notice].
7. Install the bolts (3).
Tightening torque
Tighten the bolts to 25 Nm (18 ft. lbs.).
8. Connect the electrical connectors (3, 5) to the TCM.
9. Install the manual shaft detent lever.
10. Install the battery tray.
NOTE:
DTC P0602 is set with all new service transaxle control modules. When the transaxle control module is reprogrammed with the correct software
and calibrations, DTC P0602 will be erased.
11. Reprogram the TCM with the correct calibration.
12. Perform the transmission adaptive learn procedure.
