XL-7 4WD V6-2.7L (2003)
7. Connect deployment harness connector to air bag (inflator) module (driver or passenger) or seat belt pretensioner (driver or passenger) and lock
connector with lock lever.
a. Connect connector.
b. Lock connector with lock lever.
8. Route deployment harness out the vehicle.
9. Verify that the inside of the vehicle and the area surrounding the vehicle are clear of all people and loose or flammable objects.
10. Stretch the deployment harness to its full length 10 m (33 ft) (1).
Special tool
(A): 09932-75030
11. Place a power source near the shorted end (3) of the deployment harness. Recommended application: 12 Volts minimum, 2 amps minimum. A
vehicle battery is suggested.
12. Completely cover windshield area and front door window openings with a drop cloth, blanket to similar item (2). This reduces the possibility of
injury' due to possible fragmentation of the vehicle's glass or interior.
13. Notify all people in the immediate area that you intend to deploy the air bag (inflator) module or activate the seat belt pretensioner.
NOTE:
-
When the air bag deploys and the pretensioner activates, the rapid gas expansion will create a substantial report. Wear suitable ear protection.
Notify all people in the immediate area that you intend to deploy the air bag (inflator) module or to activate the seat belt pretensioner and
suitable ear protection should be worn.
-
After the air bag (inflator) module has been deployed, the surface of the air bag may contain a powdery residue. This powder consists primarily
of cornstarch (used to lubricate the bag as it inflates) and by-products of the chemical reaction.
WARNING:
-
After deployment/activation, the metal surfaces of the air bag (inflator) module and the seat belt pretensioner will be very hot. Do not
touch the metal areas of them for about 30 minutes after deployment/activation.
-
Do not apply water, oil, etc. to deployed air bag (inflator) module and activated seat belt pretensioner. Failure to follow procedures
may result in fire or personal injury.
14. Separate the two banana plugs on the deployment harness.
15. Connect (1) the deployment harness to the power source (12 V vehicle battery) (2) to immediately deploy/activate the air bag or the pretensioner.
16. Disconnect the deployment harness from the power source (12 V vehicle battery) (2) and short (4) the two deployment harness leads together by
