XL-7 4WD V6-2.7L (2003)
12. remove rear bracket cap (2) from rear bracket (3) , and then remove brush (1) from rear bracket (3), as required.
Starting Motor Reassembly
CAUTION:
-
Washing, adjusting and disassembling of shock absorber (clutch plate) are not allowed.
-
New oilless bearing have been lubricated when they are supplied as spare parts. DO NOT wash with grease dissolving solvent nor lubricate them
with other lubricant.
1. Inspect component pants (Refer to "Starting Motor Inspection:".) and replace with new ones as necessary.
2. Apply grease (Refer to "Starting Motor Components Description:".)
3. Install armature to yoke.
4. Install brushes (1) and brush springs (2) to brush holder (3).
5. Install brush holder (3) to armature while pushing 4 brushes (1) outward.
6. Install rear bush and then rear bracket cap.
7. Install rear bracket (1).
8. Tighten brush holder screws (2).