XL-7 4WD V6-2.7L (2003)
-
Perform Steps 9) to 10) within 10 min. to ensure sufficient adhesion.
-
Be sure to refer to adhesive maker s instruction for proper handling and drying time.
10. Holding rubber sucker grips (1), place glass onto body by aligning mating marks marked in Step 3) and press it.
11. Check for water leakage by pouring water over windshield through hose. If leakage is found, dry windshield and fill leaky point with adhesive. If
water still leaks even after that, remove glass and start installation procedure all over again.
CAUTION: Upon completion of installation, note the following.
-
Do not use high pressure water.
-
Do not blow compressed air directly at adhesive applied part when drying.
-
Do not use infrared lamp or like for drying.
-
Sudden closing of door before adhesive is completely set may cause glass to become loose or to come off. Therefore, if door is opened or
closed before adhesive is completely set, make sure to open all door glasses and use proper care.
-
If molding is not securely in place, hold it down with a tape until adhesive is completely set.