XL-7 4WD V6-2.7L (2003)
Installation
1. Using cleaning solvent, clean windshield edge where windshield glass is to be adhered. (Let it dry for more than 10 minutes.)
2. Install new glass stoppers (2 pcs) to lower side of windshield and new fastener (1) to body. When reusing windshield, install new fastener (1) to
windshield.
3. To determine installing position of glass (2) to body (3), position glass against body so that clearance "a" between upper end of glass and body is
about 5 mm (0.197 in.) and clearances between each side end (right and left) of glass and body are even. Place glass so that lug of fastener is
matched with cut in body and fit fastener. Then mark mating marks (1) on glass (2) and body (3) as shown.
Upper clearance can be adjusted by moving stoppers position.
