XL-7 4WD V6-3.6L (2008)
2. Install the cruise brake switch.
^
Position the switch into the retainer with the electrical connector index notch pointing to the 1 o'clock position.
^
Slide the switch in the retainer until the plunger is fully depressed into the barrel.
^
Rotate the switch clockwise until the travel stop has been reached, approximately 60°.
^
Inspect the cruise brake switch to ensure the switch is properly locked into the switch retainer with the cruise brake switch electrical connector
index notch pointing to the 3 o'clock position.
3. Connect the cruise brake switch harness connector.
4. Install the knee bolster.
5. Install the instrument panel left lower closeout panel.
6. Use the scan tool to monitor CRUISE BRAKE SWITCH in the engine control module (ECM) General Information data table, while depressing
and releasing the brake pedal. Verify the APPLIED and RELEASED states read correctly.
