XL-7 4WD V6-3.6L (2008)
Camshaft Gear/Sprocket: Service and Repair
Camshaft Position Actuator Replacement - Bank 1 (Right Side) Intake
Camshaft Position Actuator Replacement - Bank 1 (Right Side) Intake
Removal Procedure
1. Remove the right exhaust camshaft actuator.
2. Remove the intake camshaft position actuator bolt.
3. Remove the right intake camshaft position actuator.
Installation Procedure
1. Locate the intake camshaft position actuator to the camshaft and loosely install the bolt.
CAUTION: Refer to [Torque Reaction Against Timing Drive Chain Notice].
NOTE: Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
2. Tighten the camshaft position actuator bolt.
3. Install the right exhaust camshaft actuator.