XL-7 4WD V6-3.6L (2008)
7. While holding the removal tool in place, gently pull the wire out of the back of the connector.
Always remember never use force when pulling a terminal out of a connector.
Repair Procedure
Use the appropriate terminal and follow the instructions in the J-38125.
Location of the terminal in the repair tray and the proper crimp tool can be found in the appropriate connector end view.
Yazaki Connectors (2-Way)
Yazaki Connectors (2-Way)
Special Tool
J-38125 Terminal Repair Kit
Terminal Removal Procedure
1. Disconnect the connector from the component.
2. Insert a small flat-blade tool in the slot below the front loaded terminal position assurance (TPA) and pry up.
3. Remove the TPA by pulling it out of the connector.